Hose Fittings Wholesalers Introduce Quick Metal Tips

  • The use of quick metal hose joints should comply with relevant industrial technical specifications. Hose Fittings Wholesalers introduces the following factors to be considered when purchasing:

    1. According to the corresponding use environment, select the appropriate structure and material.
      Including factors such as the humidity conditions of the operating environment, the condition of dust and whether it is easy to corrode, etc., to comprehensively consider the type, body material and sealing material of the quick connector selected. If metal hose fittings are exposed to chemically corrosive environments, such as salt water or sour gas, only stainless steel or brass fittings are required.

      2. Select the appropriate structure and material according to the type and temperature of the fluid.
      Different types of fluids, body materials and sealing materials need to be equipped with different metal hose quick connectors. If it is air, steel metal joints are recommended; if it is water, brass or stainless steel metal joints are recommended. Therefore, when purchasing metal hose joints, the consistency of the chemical composition, temperature and pressure of the fluid and the pipe joint should be considered. In order to avoid the erosion of mineral oil and synthetic fluid, most pipe joints are electroplated. If there is a rubber sealing ring as a part of the pipe joint, it must be ensured that the material of the sealing ring is suitable for the fluid.

      3. According to the structure of the automatic opening and closing valve, select the appropriate gold soft hose joint.
      The structure of the valve usually has two-way switch type, one-way switch type and two-way open type. When purchasing metal hose fittings, you have to figure out in advance which type it is. In addition to the two-way switch type, fluid may flow out of the piping during separation, so it is necessary to select a quick connector with a valve structure suitable for the piping application. The crimped metal hose joint requires less space than the detachable pipe joint, and the weight is also 15% smaller than the detachable type, which can use the effective space more economically and reduce the volume and weight of the entire system. Permanent crimping pipe joints should be used for high-pressure pipelines, because detachable joints are not easy to install on hoses reinforced with four or six layers of spiral wire.

    Through the above introduction, Hydraulic Adapters Company hopes that you can simply refer to the content of this article in future use.