stepper wire cutting machine factory maintenance common sense

• Posted by marijuanaparty marijuanaparty September 5, 2023 - Filed in Health - 431 views

  stepper wire cutting machine factory is not suitable for working in dirty and high temperature and humidity environment, the power supply environment also has higher requirements, the power supply voltage of the machine tool should not be inferior to ±10%, and the corresponding balance and stability. stepper wire cutting machine factory Too bad power grid must be installed voltage regulator. stepper wire cutting machine factory In addition to keeping the machine clean and lubricated normally, the following parts must be carefully maintained:

  stepper wire cutting machine tool guide rail and screw, must not be contaminated with dirty water and dirt, once stained with dirt, to wipe clean with clean cotton yarn and then with absorbent cotton soaked 10# oil gently rub coated again.

  stepper wire cutting machine factory Guide wheel and bearing, for the life of the guide wheel and bearing, should also be replaced with too dirty coolant, such as short time do not open the machine tool, to let the guide wheel turn for tens of seconds without water, throw out the paint, remove the guide wheel seat plug, inject grease, so that dirt discharged through the oil gap, So that the guide wheel and bearing are often in a cleaner state.

  stepper wire cutting machine factory The coupling and key on the wire cylinder shaft and the motor should be kept in a tight and secure state. Once the key is loose and the coupling crashes, the buffer pad and key of the coupling should be replaced immediately. After a long time of commutation with a gap, the keyway on the shaft will be deformed and stretched.

  stepper wire cutting machine factory The online cable between the control cabinet and the machine tool, the mopping part should be protected by a cover plate or plastic plate, and should not be trampled at will. The cable should be in a relaxed and free state, can not be pulled by external force, can not force the cable plug, and can not frac the cable corrugated sheath.

  stepper wire cutting machine factory The console (cabinet) should be handled gently when moving, and the greasy hand should not plug and remove the touch connector or keyboard.

  Any part of the bed surface shall not be knocked or collided, in particular, the wire frame and the bed surface shall not be interfered with due to over-stroke movement, which will seriously damage the machine parts or accuracy.

  It is necessary to always pay attention to the conductive block in a good conductive and insulated state between the bed, the workbench pad must be insulated with the bed, the stepper motor drag line should be in a free state, and the stepper motor ensures that there is no dirty water.

  Cars need regular maintenance and maintenance, and the same goes for machine tools. As long as the operator treats it sincerely, it will also return sincerely and bring you higher returns.

  stepper wire cutting machine factory https://www.talentcnc.com/Medium-speed-STEPPER-wire-cutting-machine