Seam welding process of bathroom wash basin and sink

• Posted by hou sen December 16, 2020 - Filed in Business - #Bathroom vanity and sink  - 1,027 views

  The bathroom vanity and sink is a tool used to collect gas or hold a large amount of water through drainage, and can be used to wash dishes and food. Its main material is stainless steel. In addition to stainless steel, there are iron enamel, ceramics and so on.

  The tank treatment is divided into four steps: welding and stretching, surface treatment, corner treatment and spraying on the bottom of the tank. The sink should be maintained and maintained. As far as the sink market is concerned, there are three types: integral stamping (also called integral stretching or joint stretching), seam welding (also called bottom welding) and butt welding. Both seam welding and butt welding belong to the molten pool.

  The most common welds on the market are produced by seam welding. This process is mainly to stretch two single tank water tanks, then press the panel, weld the two water tanks to the panel, and then perform grinding treatment. In this process, the requirements for trough stretching equipment are very low, and hydraulic equipment within 500 tons can be produced.

  The advantages of bathroom vanity and sink are: 1. The shape of the washbasin panel can be diversified, and the cost of the factory production mold is low (the water tank mold can be shared); 2. The sink panel can be made of wire drawing or embossing material, which is beautiful and generous. 3. A groove with a smaller R angle can be made, which is close to a square and has a larger use space.