How To Operate Log Splitter
-
Through this period of understanding, I believe that everyone is no stranger to Log Splitter, but these contents are not enough for customers who want to know more about this product. Today, the editor will share the knowledge about the operation of the wood chip machine with you, hoping to attract everyone's attention, so that everyone has a deep understanding of the wood chip machine. In this way, when you buy and use the wood chip machine, you can know it well, don't panic, and hope to inspire and help you.
1. To give full play to the performance of this machine, there should be no less than 2 operators;
2. There should be no iron, stone and other sundries in the material with guillotine;
3. When working, properly adjust the amount of material fed, too much will easily cause overload and stop, and too little will affect the cutting efficiency;
4. If there is a blockage during work, it is not allowed to forcibly feed it by hand or iron rods, and it should be shut down immediately to clear it;
5. During work, if an abnormality is found or an abnormal sound is heard, the machine should be shut down for inspection immediately, the power supply must be cut off before the inspection, and it is forbidden to troubleshoot while the machine is running;
6. Each movable part is filled with butter once a day, and the main bearing needs to be filled with lithium-based grease once every 300 hours;
7. When you stop working, let the Performance Built Log Splitter run idling for two minutes, blow off the dust and weeds in the machine, and then shut down.