Learn Laboratory-Scaled Rubber Extruder Machine in the Testing

• Posted by na bai May 19, 2021 - Filed in Arts & Culture - #rubber extruder machine  - 777 views

   

  To widen the variety of process relevant test methods for rubber applications, laboratory-scaled rubber extruders (with roll feeders) are available for torque rheometers. These measuring extruders are specially designed to simulate extrusion processes and simultaneously to control and evaluate the process parameters.

  The measuring rubber extruder machine can easily be equipped with a large number of dies which, according to their geometry are suitable for a variety of applications. Three different methods are presented below, which may be helpful in solving problems in the processing of unvulcanized rubber.

  Automatic Extrusion-Capillary Measurement Capillary measurements show their advantage where information about the flow behaviour of an unvulcanized compound is required as an absolute value.

  Injection moulding processes (e.g. for seals and O-rings) can be mentioned as an application, where rheological factors influence the success of the process to a great extent. Due to the narrow clearances and high rubber compound melt flow rate, extremely high shear rates can occur in the injection channels. On the other hand, the final filling of the mould is slow and the applied shear is low.

  As a rule, rubber compounds exhibit pseudo-plastic flow behaviour. Various shear stresses can be exerted on a rubber compound during processing. Because the viscosity is highly dependent on the shear rates, it is imperative that the viscosity be characterized as a function of the relevant shear rates. The processing engineer’s main goal is the determination of these relationships for the injection moulding process.

  In the case of extrusion capillary measurements the compound is forced through a slit capillary and a rod capillary die. The slit capillary die covers a shear rate range that usually accurse in extrusion process. The material flow in the smaller rod capillary reaches much higher shear rates, which correlate more with the injection moulding process. The rheological factors are calculated from the differential pressure and the volumetric flow rate.

  The great advantage of extrusion-capillary measurements is that the sample is made to flow under process conditions.

  As this test can be run fully automatically, it is also suitable for fast and very accurate quality control differentiation of different batches.

  Die Swell Behavior Apart from the viscosity, the elasticity of the polymer melt greatly influences the processing and the end product. Tire components like tread profiles have to be extruded in very narrow tolerances. The success of this process depends on the evenness of the raw rubber polymer which is used for the compound. If this basic material differs slightly in its elastic behaviour, the given tolerances for the end product, such uniformity, cannot be reached. To ensure that your process does not run out of tolerance, the die-swell test can be a useful quality control instrument.

  For this test, which can be directly linked to the above described capillary measurement, a laser sensor simultaneously measures the swell of the extruded strand. The viscosity and die-swell, which is a measure of the elasticity, is evaluated as a function of the applied shear rate. The tests show very clearly, that the viscosity behaviour of both compounds show shear thinning and scarcely differ. On the other hand the elastic behaviour of both samples is extremely different. With this information, the processing of a compound can be easily optimized. Time and money-consuming empirical tests for e.g. designing a new die on production-scaled machines can be minimized.