Categories
Tags
-
#epdm extruder rubber hot air oven
#rubber extruder rubber curing oven
#rubber extruder machine
#rubber curing oven rubber extruder machine
#epdm extruder rubber curing oven
#rubber curing oven rubber extruder machine
#epdm extruder salt bath curing line
#rubber extruder machine rubber hot air oven
#rubber extruder machine rubber curing oven
#rubber extruder machine rubber curing oven
#rubber extruder machine rubber vulcanizing machine
#PLC
#touch screen control
#manual and automatic control can be realized; automatic mold clamping
#automatic exhaust
#automatic pressure compensation
#automatic temperature control
#vulcanization timing
#alarm and automatic mold opening can be realized; the touch screen displays and controls the hot plate in time The temperature of each heating zone.
#rubber extruder machine rubber extrusion production line
#rubber extruder machine rubber extrusion production line
#rubber extruder machine rubber hot air oven
#rubber vulcanizing machine rubber extruder machine
#rubber extruder machine salt bath curing line
#rubber extruder machine salt bath curing line
#rubber extruder machine rubber extrusion production line
#rubber extruder
#Rubber
Archives
What is the Troubleshooting Method for Rubber Extruder Machine?
-
Posted by na bai - Filed in Arts & Culture - #rubber curing oven rubber extruder machine - 1,020 views
Troubleshooting of rubber extruder machine:
1. Due to the low air or oil pressure, the automatic screen changer of the rubber extruder will be slow or even inoperable. In addition, the air and oil leakage of the cylinder and the hydraulic station will also cause this problem. . Facing this kind of problem, the relevant operators need to check the sealing condition of the power system of the screen changer and the air cylinder or hydraulic cylinder to avoid the recurrence of this kind of problem.
2. When the torque of the extrusion system of the rubber extruder is too large and the main motor and the input bearing are not connected together, the safety pin or safety key of the rubber extruder may be cut off. At the same time, firstly check the preheating time and observe whether the heating value meets the requirements. Secondly, check the extrusion system to observe whether the screw is stuck by metal or other objects.
3. In the daily work of the rubber extruder, sometimes the extrusion volume suddenly drops. If this happens, it may be that the feeding system has malfunctioned, or there may be no material in the hopper. If it is caused by this reason, you need to carefully check the feeding system to find out the problem, or fill in the appropriate material; in addition, this problem can also occur if the screw is jammed, which requires the extrusion system Checked and cleaned up.
4. During the operation of the rubber extruder, if the feeding is uneven, the main motor current will be unstable, and the main motor bearing will be damaged or poorly lubricated; a certain section of the heater fails and does not heat; the screw adjustment pad is wrong, or Incorrect phases will cause this to happen, so check the feeder, repair main motor and heater frequently to prevent this from happening.
In daily work, mechanical equipment will inevitably have some failures, and in order to reduce the incidence of these failures, it is necessary for staff to conduct regular inspections and maintenance on them, so that these mechanical equipment can work smoothly.Welcome to visit rubber curing oven if you have any interests!