Clean End Cap Machine Regularly

• Posted by Gold eagle August 13, 2020 - Filed in Arts & Culture - #end cap machine Two-piece Cans Making Machine  - 1,048 views

   

  1. Take the Machine Apart

  First, unplug your end cap machine. Take out the bobbin casing, lower the race cover and remove the hook. Take off the presser foot and throat plate.

  2. Grab a Brush

  Brush out any lint that's built up in the bobbin casing and throat plate.

  Pro Tip
  Most machines come with a small plastic brush, though any anti-static brush or pipe cleaner will work. (You can usually find them at office supply stores.) Skip canned air though: it can invalidate your machine's warranty and push lint further into the machine.

  3. Oil the Machine

  Check your manual for detailed instructions on if, when and how to oil your machine. (Some are self-lubricating, so if that's the case you can — and should! — skip this step.)

  Pro Tip
  A little oil goes a long way and yes, it's totally possible to over-oil your machine. If that's happened, run some muslin or scrap fabric through the machine until it comes out clean and without oil stains.

  4. Reassemble the Machine

  Place the hook, bobbin casing and throat plate back in their respective places. Change your needle and reattach the presser foot. Replace the bobbin, thread your machine and you're ready to sew!

  
  The Two-piece Cans Making Machine is also one of our products, welcome to your come and purchase!