china vertical turret milling machine safety operating rules

• Posted by marijuanaparty marijuanaparty September 5, 2023 - Filed in Just for Fun - 524 views

  1. china vertical turret milling machine Operating procedures:

  1. Turn on the machine power supply, controller switch, 24V stepper drive power switch and high pulse power switch.

  2, according to the drawing size and the actual situation of the workpiece calculation seat point programming, pay attention to the workpiece clamping method and molybdenum wire diameter, select a reasonable cutting position.

  3, open the wire motor, pump motor and control panel on the high frequency switch.

  4, put the coarse switch in the automatic position, unplug the feed switch, that is, enter the processing stage, processing and further adjust the fine-tuning switch and software fine-tuning, so that it is adjusted to the most stable state of processing.

  5, after the end of the processing should be in order to turn off the high-frequency pulse switch of the machine tool, the water pump switch, in the closing of the coarse closed wire cylinder switch, if you want to shut down the brake simply press the red button of the total power switch.

  2, china vertical turret milling machine use precautions:

  1, before starting, check whether the electrical parts are loose, if there is a broken wire and parts fall off should promptly notify the professional maintenance.

  2, check the tension of molybdenum wire.

  3, check whether the guide wheel is damaged and timely change the position of the working face to prevent the broken molybdenum wire.

  4, check the stop rod if there is a communication slot, should adjust the position of the working face in time to prevent the broken molybdenum wire.

  5, check the lubrication parts of the machine tool should have enough lubricating oil.

  6, daily maintenance:

  6.1, transverse feed gearbox and longitudinal feed gearbox, each shift should add 30 oil once.

  6.2, each drive shaft of the wire storage cylinder, the screw nut of the wire storage cylinder, and the guide machine of the drag plate of the wire storage cylinder, each plate should add No. 30 oil once.

  china vertical turret milling machine https://www.talentcnc.com/Turret-milling-machine