We Give Advice On How to Install Blanket For Fully Automatic He

• Posted by gaobao Gary October 10, 2021 - Filed in Arts & Culture - #heat transfer foil suppliers fully automatic heat transfer printing machine  - 1,030 views

   

  The rotary heat transfer calandra will be worn out due to the loss of the felt during the production process. When the felt is replaced, the original felt of fully automatic heat transfer printing machine cannot be used. Because the felt is directly mounted on the surface of the drum, if the quality of the felt is not good, it will directly affect the normal operation of the thermal transfer printing machine.
  The adjustment of the felt offset is the latter process of the overhaul process. It mainly includes the following tasks: quality inspection and acceptance of the blanket; whether the blanket is stable during operation. After installation, the blanket is not shaped and will not go wrong.
  1. Whether the staff of the blanket installation is professional and the personnel operation is standardized.
  2. thermal transfer printing machine blanket installation, generally use the following two methods:

  1. Fix the felt on the surface of the drum, pass the shaft through the blanket, clamp it in the fixing groove of the felt, rotate the elastic tight loop of the felt, adjust the looseness of the felt so that the bottom can pass through the other shaft, then tighten the screw and fix it. Mechanical shaft, view the width of both sides of the blanket.

  2. The machine must be level during the blanket installation process. The machine horizontal method can use the other end of the base bolts 1 and 2 to place the required height plates, such as h, b2, b3 and b4. Then level with the level on the upper surface of the base. When the stand is level in both the vertical and horizontal directions, tighten the anchor bolts 1 and 2. Then add the pad on both the anchor bolt 3 and the reading, and level it in the same way. After leveling, tighten the foot | bolts 3 and 4, and the base is installed. This method is a three-point leveling installation method at the construction site S.

  
  After heat transfer machine blanket is installed, it is usually a test machine. The new blanket will have a slight deviation. After several times of setting, it will be fine.

  
  If you still don't know how to install, it is best to find a professional engineer to install.